DVIR Rules (49 CFR 396.11) and How to Certify Repairs

What 49 CFR 396.11 asks of drivers, carriers and the shops that fix their trucks: who prepares a DVIR, what it must cover, the no-defect rule as written today, how to certify repairs, how long records are kept, and what your paperwork should show.
Under 49 CFR 396.11, drivers write a DVIR at the end of each day's work on each vehicle when a defect is found or reported. Before the truck runs again, the carrier or its agent, such as your shop, repairs safety defects and certifies on the DVIR that each was repaired or needs no repair. Carriers keep it three months.
This guide is for diesel and heavy-equipment repair shops that fix trucks after a driver writes them up, and for maintenance managers who sign DVIRs for their own fleet. It reads 49 CFR 396.11 line by line, with 396.13 and 396.7 where they connect, using the eCFR text as of November 19, 2026.
It's general information, not legal advice. Carriers should check the current rule and their own obligations. For where DVIRs sit in the rest of Part 396, start with 49 CFR Part 396 explained for repair shops.
Who must prepare a DVIR
The carrier "shall require its drivers to report, and every driver shall prepare a report in writing at the completion of each day's work on each vehicle operated" (396.11(a)(1)). Three things follow from the text:
- The driver writes it, at the end of the day's work. The start-of-day step is the driver's review under 396.13, covered below.
- One report per vehicle. "If a driver operates more than one vehicle during the day, a report must be prepared for each vehicle operated" (396.11(a)(2)(i)).
- A report is needed when there's a defect. The no-defect rule is below.
Three kinds of operation are exempt from 396.11: "a private motor carrier of passengers (nonbusiness), a driveaway-towaway operation, or any motor carrier operating only one commercial motor vehicle" (396.11(a)(5)). Intermodal chassis have their own report rule, 396.11(b), covered near the end.
What a DVIR must include
The report "shall cover at least" these parts and accessories (396.11(a)(1)):
- Service brakes, including trailer brake connections
- Parking brake
- Steering mechanism
- Lighting devices and reflectors
- Tires
- Horn
- Windshield wipers
- Rear vision mirrors
- Coupling devices
- Wheels and rims
- Emergency equipment
It must "identify the vehicle and list any defect or deficiency discovered by or reported to the driver which would affect the safety of operation of the vehicle or result in its mechanical breakdown" (396.11(a)(2)(i)). The driver signs it. On a two-driver team, one signature is enough, "provided both drivers agree as to the defects or deficiencies identified" (396.11(a)(2)(ii)). Section 396.11 doesn't prescribe a form.
The no-defect rule as written today
The current text: "Drivers are not required to prepare a report if no defect or deficiency is discovered by or reported to the driver" (396.11(a)(2)(i)). FMCSA dropped no-defect reports for property carriers on December 18, 2014 (79 FR 75437) and for passenger carriers on September 17, 2020 (85 FR 50787).
When FMCSA made electronic DVIRs explicit in February 2026, a commenter asked it to bring no-defect reports back. The agency declined, saying there is no basis for making drivers document a shift with no defects, "regardless of whether it is performed electronically" (91 FR 7893).
Two things stay the same. Before driving, the driver must still "be satisfied that the motor vehicle is in safe operating condition" (396.13(a)). And a carrier can still ask its drivers for a report every day as company policy. The federal rule doesn't require it.
Certifying repairs: what 396.11(a)(3) requires
The rule sets two duties, both before the vehicle runs again, and both on the carrier "or its agent":
- Repair. "Prior to requiring or permitting a driver to operate a vehicle, every motor carrier or its agent shall repair any defect or deficiency listed on the driver vehicle inspection report which would be likely to affect the safety of operation of the vehicle" (396.11(a)(3)(i)).
- Certify. "Every motor carrier or its agent shall certify on the driver vehicle inspection report which lists any defect or deficiency that the defect or deficiency has been repaired or that repair is unnecessary before the vehicle is operated again" (396.11(a)(3)(ii)).
Safety isn't the only test. 396.7(a) separately bars running a vehicle in a condition "likely to cause an accident or a breakdown," and FMCSA's guidance adds defects that fail Appendix A, as our DOT inspection requirements guide explains in its step-by-step sign-off. Mark an item "repair unnecessary" when it checks out fine, or when it has no bearing on safe operation, breakdown risk or Appendix A. Write down why.
Roadside inspection violations follow the same rule: the carrier corrects them "in accordance with § 396.11(a)(3)" (396.9(d)(2)).
Who signs, and where
Because the rule says "motor carrier or its agent," a shop doing the repair for the carrier can sign the certification. It goes on the DVIR itself, not on a separate log.
Then, before driving, the next driver reviews the last DVIR and signs it "to acknowledge that the driver has reviewed it and that there is a certification that the required repairs have been performed" (396.13(b) and (c)). That signature isn't needed for listed defects on a towed unit that is no longer part of the combination (396.13(c)).
How to write the certification
Part 396 doesn't set the wording. FMCSA's example forms (page 2) show a DVIR with two boxes, "Above defects corrected" and "Above defects need not be corrected for safe operation of vehicle," then the mechanic's signature and date and the driver's signature and date.
When a report lists several items, a line per defect is clearer. For example:
| Defect as the driver wrote it | What the shop did | Certification |
|---|---|---|
| Left rear marker lamp out | Replaced lamp and pigtail, tested all lamps | Repaired |
| Air leak at trailer glad hand | Replaced glad hand seal, no leak on retest | Repaired |
| Horn weak | Tested, horn sounds normally, no fault found | Repair unnecessary: no defect found |
| Scuff on sleeper fairing | Inspected, cosmetic only | Repair unnecessary: no effect on safe operation |
Under the lines: the certifier's name and signature, the date and time, your shop's name and your work order number.
When the part isn't in yet
If a listed defect is likely to affect safe operation, the vehicle doesn't run until it's repaired (396.11(a)(3)(i)). Don't certify "repaired" for work that hasn't happened, and don't leave the certification blank while the truck rolls. Put the parts hold on the repair order and tell the carrier in writing. If a fix is temporary, write that down so the permanent repair gets scheduled.
How long DVIR records are kept
The carrier keeps "the driver vehicle inspection report, the certification of repairs, and the certification of the driver's review for three months from the date the written report was prepared" (396.11(a)(4)).
The repair itself also goes in the carrier's maintenance record, with its "date and nature," and that record is kept 1 year, and for 6 months after the vehicle leaves the carrier's control (396.3(b)(3) and (c)). Keep your own repair orders on your own schedule, longer than three months.
Electronic DVIRs
Since March 23, 2026, 396.11 says the report "may be created and maintained in electronic format, in accordance with 49 CFR 390.32" (396.11(a)(6)), and 396.13(d) says the same for the driver's review (91 FR 7893). FMCSA said DVIRs could already be done electronically and that paper DVIRs remain allowed.
Section 390.32 sets the conditions. Electronic records must "accurately reflect the information otherwise required." They also have to be retainable, used for the purpose they were created for, reproducible within required timeframes, and backed by proof of consent to electronic records under 15 U.S.C. 7001(c) (390.32(d)). Anyone who must sign or certify may use an electronic signature (390.32(c)).
Our reading: an e-signed certification works when the carrier can pull up the DVIR, the certification and the driver's review together when asked.
Intermodal chassis: 396.11(b)
For equipment from an intermodal equipment provider, the driver or carrier reports known damage, defects or deficiencies when the equipment goes back (396.11(b)(1)). The report covers:
- brakes, lighting devices, lamps, markers and conspicuity marking;
- wheels, rims, lugs and tires;
- air line connections, hoses and couplers, and the king pin upper coupling device;
- rails or support frames, tie down bolsters, locking pins, clevises, clamps or hooks;
- sliders or the sliding frame lock.
The provider or its agent repairs safety defects and certifies "on the original driver's report" before the equipment runs again, and keeps the paperwork 3 months (396.11(b)(3) and (4)). If you repair chassis for a provider, the same habits apply.
What a repair shop's paperwork should show
The rule sets the certification. The rest of this list is good practice that makes the certification easy to defend:
- The DVIR's date, the unit number and the driver's listed defects, copied exactly onto the repair order.
- For each defect: what you found, what you did, the parts used, the tech and the date.
- "Repaired" or "repair unnecessary" for every listed item, with a reason for each "unnecessary."
- The certification on the DVIR itself, signed or e-signed and dated by the person certifying for the carrier.
- Your work order number on the DVIR, and the DVIR date on the work order, so either one leads to the other.
- A copy to the carrier the day the truck leaves.
- Any defect you weren't approved to fix, flagged in writing, with a note that the vehicle shouldn't run if it affects safety.
Written approvals keep this clean. See getting repair approvals in writing.
Where MetaFleet fits
MetaFleet runs digital inspections on your shop's own forms, so your DVIR repair sheet stays your form, and techs fill it in from any phone browser. Fleet customers approve each repair on the estimate from a link, which puts the go-ahead in writing before the work starts. PM programs and reminders keep each truck's next scheduled service in view. The certification, and the call on what's safe, stay with the carrier and your techs.
See inspection and preventive maintenance software for diesel shops, or book a demo.
Sources (10)
Rule text checked against the eCFR on November 19, 2026 (eCFR current through November 18, 2026). The last change to 396.11 and 396.13 took effect March 23, 2026.
- eCFR: 49 CFR 396.11, driver vehicle inspection reports
- eCFR: 49 CFR 396.13, driver inspection
- eCFR: 49 CFR 396.7, unsafe operations forbidden
- eCFR: 49 CFR 396.9, inspection of motor vehicles and intermodal equipment in operation
- eCFR: 49 CFR 396.3, inspection, repair, and maintenance
- eCFR: 49 CFR 390.32, electronic documents and signatures
- Federal Register: 91 FR 7893 (Feb 19, 2026; effective Mar 23, 2026), electronic DVIRs
- Federal Register: 79 FR 75437 (Dec 18, 2014), DVIR no-defect rescission for property carriers
- Federal Register: 85 FR 50787 (Aug 18, 2020; effective Sep 17, 2020), passenger carrier no-defect DVIRs
- FMCSA: example annual inspection report and DVIR (PDF)
FAQs
Ready to close out DVIR repairs cleanly?
See MetaFleet in Action
Book a demo and we'll walk through how your shop handles DVIR write-ups and repair sign-offs today, show you where MetaFleet fits, and build a simple rollout plan your team can follow.
Not ready to talk? Try a free shop tool
Related Articles

49 CFR Part 396 Explained for Repair Shops
A plain-language tour of the federal inspection, repair and maintenance rule for shops that work on fleet trucks: what each section of Part 396 asks, what the carrier owns, what the shop does, and the records a shop should hand back.

DOT Annual Inspection Checklist (49 CFR 396.17) and Who Can Perform It
Appendix A to Part 396 as a working checklist, group by group, plus who qualifies to inspect under 396.19, the separate rules for brake inspectors under 396.25, what goes on the report and the decal, and how often each unit needs one.
